Basic HTML Version
Flasher Test Continued ...
Run-
The Run mode allows you to cycle through the i1ashlamps automatically.
Press
the Enter button during the Stop mode. The display shows the name and number of the circuit
currently being pulsed. and the corresponding bulb(s) flashes.
Either press the Enter button to return to the Repeat mode or. press the Escape button to return to
the Test Menu. Once in the Test Menu. press the Up button to display the next test, (or the Down
button to return to a previous test). Press the Enter button to activate the test.
T.6 General
Illumination
Once the test name is shown under the Test Menu. press the Enter button. This test allows you to
check all of the General Illumination circuits. There are two modes of operation. Stop and Run.
To obtain wire color. driver number. connector. and fuse information. press the Start button
when the desired General Illumination circuit appears in the display.
Stop -
Press the Up or Down buttons to cycle through the General Illumination Test manually.
All illumination is tested first. followed by an individual circuit test. The circuit name and
number shows in the display while the corresponding lamps lights. If any other results occur the
system has detected an error.
Run-
Press the Enter button any time during Stop mode and the General Illumination Test
cycles through automatically.
For each circuit shown in the display the corresponding bulbs
should light. If any other results occurs the system has detected a problem.
Either press the Enter button to return to Stop mode. or the Escape button to return to the Test
Menu. Once in the Test Menu press the Up button to advance to the next test, (or the Down button
to return to a previous test). Press the Enter button to activate the test.
T.7 Sound and Music Test
Once the test name is shown under the Test Menu. press the Enter button. The Sound and Music
Test allows you to check the audio circuits. This test has three modes for testing the sound and
music circuits. Run. Repeat and Stop.
Run
The Run mode steps through a sequence of sounds and music. Pressing the Up or
Down button during this portion of the Sound and Music test allows you to advance to a
particular sound or tune without having to wait for the program to play all the sounds available
in the test.
A sound or tune should be heard for each name and number that appears in the
display. Any other results indicates the system has detected a problem.
Repeat -
Press the Enter button at any time during the Run mode to cause the program to
stop and repeat a particular sound or tune. The same sound should repeat continuously until the
Up or Down button is pressed. Any other results indicates the system has detected a problem.
Stop -
Press the Enter button at any time during the Repeat mode to stop this test
altogether.
Nothing should be heard. Any other results indicates the system has detected a
problem.
Use the Enter button to return to the Run test mode. or the Escape button to return to the Test
Menu. Once in the Test Menu press the Up button to display the next test. (or the Down button to
return to a previous test). Press the Enter button to activate the test.
The Getaway 1-15