Basic HTML Version
T.8 Single Lamp Test
The number assigned to each lamp indicates the lamp's position in the matrix. The number on
the left indicates the column. The number on the right indicates the row. Example- Lamp 23
means 2nd column. 3rd row.
Once the test name is shown under the Test Menu. press the Enter button. This test allows you to
test each lamp circuit individually. Press the Up or Down button to cycle through this test. For
each name and number that is shown in the display the corresponding lamp should light. Any
other results indicates the system has detected a problem. Press the Start button to obtain wire
color. connector. and fuse information when the desired lamp is lit.
Press the Escape button to return to the Test Menu. Press the Up button to display the next test,
(or the Down button to return to a previous test). Press the Enter button to activate the test.
T.9 All Lamps Test
Once the test name is shown under the Test Menu. press the Enter button. This test causes all the
controlled lamps to flash at the same time. Every controlled lamp should flash. Any other
results indicates the system has detected a problem.
Press the Escape button to return to the Test Menu. Press the Up button to display the next test,
(or the Down button to return to a previous test). Press the Enter button to activate the test.
T.IO Lamp and Flasher Test
Once the test name is shown under the Test Menu. press the Enter button. This test causes all the
flashlamps and the controlled lamps to flash at the same time. The controlled lamps blink.
while the flashlamps cycle from highest to lowest. Any other results indicates the system has
detected a problem.
.
Press the Escape button to return to the Test Menu. Press the Up button to display the next test.
(or the Down button to return to a previous test). Press the Enter button to activate the test.
T.11 Display Test
Once the test name is shown under the Test Menu. press the Enter button. This test automatically
checks every dot in the Dot Matrix Display. A series of patterns appear in sequence.
Each
pattern turns On and Off a section of dots. Every dot on the matrix display should be turned On
and Off during this test.
Press the Escape button to return to the Test Menu. Press the Up button to display the next test,
(or the Down button to return to a previous test). Press the Enter button to activate the test.
T.I2 Supercharger Test
Once the test name is shown under the Test Menu. press the Enter button. This test allows the
operator to check the magnets of the Supercharger Indlvidually. At the start all of the magnets
are disabled. The Up and Down buttons allow the operator to cycle through the eight different
combinations of magnets enabled or disabled.
The magnets and corresponding optos are
numbered across the device 1. 2. 3 from left to right.
Example of the screen:
# 1)
#
2)
#
3)
Coils
Disabled
Enabled
Disabled
Switches
Closed
Closed
Closed
The Getaway 1-16