Basic HTML Version
PINBALL GAME ASSEMBLY INSTRUCTIONS
1. Open the shipping container; remove all cartons, parts, and other items, and set them aside.
2.
Place the cabinet on a support and attach rear legs (after installing the rear leg spacers on the shaft of
the leg levellers), using leg bolts. Rear leg spacers, leg levellers and leg bolts are provided among
the parts in the cash box.
3.
Attach the front legs (after installing leg levellers), using leg bolts. See Figure 3 for details.
See
Detail View
---
Leg Spacer
02-4341
i""
I'
I ~
I
I
I \ : I
-
I
v
v
_0
-
..,
'1
C-10843
Leg
8-7377
Leg Leveller
Shaft
FootPad
DetaiI View-
Leg Leveller
Figure 3.
Pinball
Assembly,
Playfleld Pitch Angle,
and Leg Leveller
Details.
4.
Reach into the cabinet and backbox and ensure that the interconnecting cables are free to move
(not kinked or pinched). Be careful to avoid damaging wires at any stage of the assembly process.
5.
Raise the hinged backbox upright and stabilize it into position. Unlock the backbox, and remove the _
backbox glass, storing it carefully to avoid scratches. Remove the shipping block holding the Insert
Board. Unlatch the Insert Board and open it; lift the Speaker/Display Panel and lay it on the playfield
glass. This allows access to the bolt holes used for securing the backbox upright. Install the washer-
head mounting bolts through the bottom holes of the backbox into the threaded fasteners in the
cabinet to secure the backbox.
Remount the Speaker/Display Panel; close the Insert Board and
latch it in position. Reinstall the backbox glass, and lock the backbox.
(WARNING)
FAILURE
TO
INSTALL
the backbox mounting hardware properly can cause
personal injury.
NEVER TRANSPORT
a pinball game with the hinged backbox
erect.
Always
lower the backbox forward onto the playfield cabinet on a layer of
protective material to prevent marring or damage and possible personal injury.
6.
Extend each leg leveller
sJightlybelow
the leg bottom, so that all four foot pads are extended about
the same distance.
Remove the cabinet from its support and place it on the floor.