Basic HTML Version
A.1 30 POWER SAVER LEVEL
When General Illumination Power Saver (A.1 29) is set for 2 to 60 minutes, the Power Saver
Level controls the intensity of the general illumination and controlled lamps after the game has
been idle for the specified period of time.
Settings:
4 to 7 (4
=
dimmest, 7
=
brightest)
Factory Default: 5
Settings:
YES - Ticket Expansion board is connected.
NO - Ticket Expansion board is NOT installed in the game.
A.131 TICKET EXPANSION BOARD
When a Ticket Expansion board is connected, full control of the ticket dispenser is available. This
includes a ticket low/error lamp, resume on ticket jam switch and manual ticket dispense switch.
Factory Default: NO
A.1 32 NO BONUS FLIPS
The activation of flippers during the end of ball "bonus" sequence. Setting to "YES" may extend
the life of the flipper mechanisms.
Settings:
YES, NO
Factory Default: YES
Settings:
NEVER - Do not allow a new game start until the current game is over.
SLOW - Restart if the Start button is pressed continuously for over 1/2 second.
This helps to prevent the unintended restart of the game in progress.
INSTANTLY - Restart as soon as the Start button is pressed.
A.133 GAME RESTART
When you press the Start button during or after the 2nd ball, the game in progress ends and a
new game begins. This adjustment has three settings to determine how to handle this.
When you press the Start button during game over, or during the 1st ball (to add a
player), it is always handled instantly.
Factory Default: SLOW
A.1 34 ALLOW CHASE BALL
The Chase Ball feature will attempt to keep a game operational in the event that a ball becomes
stuck on the playfield. After a number of unsuccessful ball searches, the game software will end
the player's current ball, give a bonus award, then serve a new ball (or end the game if that was
the last ball in the player's game). This ball 'chases' the stuck ball on the playfield and will
hopefully knock it loose.
Setting this adjustment to NO will revert to the previous WPC behavior of searching endlessly
until the stuck ball becomes freed, or the machine's power is tumed off and back on.
Settings:
YES, NO
Factory Default: YES
1-30