• November 08, 2024, 10:14:01 PM

Login with username, password and session length

NOTE: This forum is for respectful dialog and it's content is meant to be kept on this site - so please be respectful and please do not copy content to other sites.
« previous next »
Pages: [1]   Go Down

Author Topic: LED interference (EMI/RFI)  (Read 14527 times)

Offline Bmore

  • PPS Forum Member
  • One Star Member
  • *
  • Posts: 45
  • Karma: +0/-0
    • View Profile
LED interference (EMI/RFI)
« on: January 19, 2016, 02:11:06 PM »
Hi

It seems that MMR is not shielded very well against electronic interference caused by LEDs, if for example I change LED intensity in the test settings I can hear the high pitch buzz/hum on the speakers. I installed the Laserrific topper, and the pulsating LED caused a really annoying interference on the speakers that I couldn't eliminate. I even tried ferrite clamps, but it still remained

Does anyone have any good suggestions on how to minimize LED interference, or is this just an inherent part of the architecture (maybe beaglebone)?
Logged

Offline Spacecake

  • PPS Forum Member
  • One Star Member
  • *
  • Posts: 9
  • Karma: +0/-0
    • View Profile
Re: LED interference (EMI/RFI)
« Reply #1 on: January 19, 2016, 02:30:49 PM »
You can use a stand alone power supply for the topper..that would probably work ok...
For the playfield led's...then I would go for speaker filters..or just one or two condensators if you want it cheap....

 
Logged
Pages: [1]   Go Up
« previous next »