• April 28, 2024, 09:12:12 PM

Login with username, password and session length

NOTE: This forum is for respectful dialog and it's content is meant to be kept on this site - so please be respectful and please do not copy content to other sites.

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Fuse

Pages: [1]
1
MMR Support [MMR Members Only] / Random multiball
« on: September 09, 2016, 10:49:06 PM »
Sorry if this has been asked, but is anyone getting random 4 ball multi balls? It may or may not be limited to 4 player games and when you attempt a super skill shot. Your playing away then you hear the trough kicking out the other 3 balls. When you lose one ball it keeps going until all are drained, it thinks that you really are to be awarded a 4 ball multi ball, anyone?

2
MMR Support [MMR Members Only] / Castle lock 3 light not working
« on: June 10, 2015, 11:29:03 PM »
I thought because I had the game on normal that you only lock 2 balls then multi ball starts and if you played it on the hard setting you would have to lock 3 balls first. So I just thought that the castle lock 3 would never light. Well I watched it in attract mode and thought it was funny that it didn't light. Went into single lamp test and selected it and it will not light. Lifted the Playfield and if I wiggle or hold the connector it will light. However I cannot keep it lit once I take my hand off the connector. Wiggled the wires below the connector and it wouldn't light.  So I'm assuming it's a cold solder on  the other side of the Playfield.  I really hope this isn't the case since all the connectors are hot glued and plenty of them.  I haven't done it but I think another connector could be swapped and go through the lamp test to see if the castle lock 3 lamp test would light another insert. That would prove the connector is good. Is this test ok to try Lloyd. All connectors have the same ground pinout?

3
MMR Support [MMR Members Only] / Slingshot Damage
« on: May 30, 2015, 10:19:07 PM »
This issue was brought to my attention on pinside so I checked out mine.  Damage has been done.  Do I need to contact cgc directly? Thanks

4
MMR Support [MMR Members Only] / Right tower falls off
« on: May 29, 2015, 11:46:58 PM »
Hey guys, just finished putting all my cliffy's on when I noticed the right tower was off its pedestal. I thought maybe it came like that so I put it back on. Well tonight it fell off again. Not really holding real tight and it is the most violent tower. Should I just throw so adhesive or some pvc cement on it.
  Thanks

Pages: [1]