Topics

1

MMR Support [MMR Members Only] / Ball Clipping Right Post During Multiball

« on: January 14, 2017, 05:58:46 PM »

This might be hard to explain.

I keep running into an issue where, during multiball, the balls often clip the right post/rubber when rolling down, activating the switch and causing the balls to get shot to the left. This usually doesn't happen when a single ball rolls down the right side during regular gameplay. It cleanly rolls down to the right flipper. I have confirmed that the table is level. Any idea why this happens and if it is a normal quirk?

2

MMR Support [MMR Members Only] / Diffuser Help...

« on: May 26, 2016, 04:31:53 PM »

I am in the process of installing my diffuser, starting with the smaller bits first and I have a couple of questions:

1 - If you look at the picture of L78 RIGHT, it has three screws and sits nice and flush against the bottom of the playfield.  However, the board for L78 LEFT only has two screws and one open hole.  Since both L78 styrene pieces have three holes, I thought maybe one of the screws fell out.  However, I see no indication that a screw was ever placed there, as there is no hole in the playfield.  As a result, the piece doesn't really sit flush.  Is this normal?

2 - In the instructions (at the end), it says to re-install L74 and L86 OVER the existing large piece of styrene.  I'm pretty sure these are the Shoot Again and the bottom king insert.  So, just to clarify, I'm supposed to install the big board first, and then install these smaller ones OVER it?  So you're basically doubling up on those inserts?  Seems kind of odd, or am I missing something here?