1
MMR Support [MMR Members Only] / Re: Trying to get in contact with CGC
« on: July 12, 2016, 09:24:17 PM »
Thanks for the heads up.
- May 05, 2024, 02:26:54 PM
NOTE: This forum is for respectful dialog and it's content is meant to be kept on this site - so please be respectful and please do not copy content to other sites.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
MMR Support [MMR Members Only] / Trying to get in contact with CGC
« on: July 12, 2016, 03:24:07 PM »
I'm trying to contact CGC to find out the tracking # for my replacement board that was supposedly sent out. I contacted UPS and they have nothing listed as being scheduled for delivery to my address. But I was told by CGC it was shipped.
Their phones are down. And all emails bounce back or fail.
Is their an alternate #. As my distributor cannot contact them. I can not contact them. The only person I can get a hold of is Lloyd. But he can also not get in touch with them at the moment. And does not have access to that information unfortunately. But tried to help.
Their phones are down. And all emails bounce back or fail.
Is their an alternate #. As my distributor cannot contact them. I can not contact them. The only person I can get a hold of is Lloyd. But he can also not get in touch with them at the moment. And does not have access to that information unfortunately. But tried to help.
3
MMR Support [MMR Members Only] / Re: Mmr update not working
« on: June 28, 2016, 12:22:21 AM »
Checked the pins in the SD port after with a DMM.
Yup. there are 2 bad pins that don't really connect 100% to the SD card.
Yup. there are 2 bad pins that don't really connect 100% to the SD card.
4
MMR Support [MMR Members Only] / Re: Mmr update not working
« on: June 27, 2016, 06:39:39 PM »
Well it 100% must be a faulty SD card slot on my machine.
Because it actually started to update but then failed 1/2 the way through.
Now my MMr is bricked. It continually boot cycles.
Only course of action is now is a new board.
I understand manufacturing defects happen but......
Very unimpressed. And extremely pissed off.
Not only can I not update. But now I can't even play it.
Ticket filed.
Because it actually started to update but then failed 1/2 the way through.
Now my MMr is bricked. It continually boot cycles.
Only course of action is now is a new board.
I understand manufacturing defects happen but......
Very unimpressed. And extremely pissed off.
Not only can I not update. But now I can't even play it.
Ticket filed.
5
MMR Support [MMR Members Only] / Mmr update not working
« on: June 27, 2016, 03:49:23 PM »
I have tried multiple SD cards. Followed the instructions to the letter. Multiple ways of unpacking the file.
My MMr will not boot to the update in progress screen.
With the SD card/cards in. It stays a blank screen for about
2-3 minutes then boots normally.
No update screen etc.
If I remove the SD and turn on it boots normally.
I filed a ticket. But does anyone have any suggestions other than possibly a faulty SD card slot on the beagle.
Thanks Eric.
My MMr will not boot to the update in progress screen.
With the SD card/cards in. It stays a blank screen for about
2-3 minutes then boots normally.
No update screen etc.
If I remove the SD and turn on it boots normally.
I filed a ticket. But does anyone have any suggestions other than possibly a faulty SD card slot on the beagle.
Thanks Eric.
Pages: [1]