16
MMR Support [MMR Members Only] / Re: Flipper Assembly
« on: May 20, 2015, 11:24:55 PM »
So there were 2 screws in the bottom of the machine that probably got loose during handling.
One of these was surely from the flipper assembly, the other wasn't as it was way too long. The other screw I found that waa probably from the flipper assembly was way too short (less than the 1/4"). The one that remained on the right assembly bracket had a lock washer (which is better than in the schematic).
Anyway, I can only assume that only a single screw was put on each bracket instead of two.
In any case, it was a less than 5 minutes fix to put new screws (with lock washers).
It now plays great!
One of these was surely from the flipper assembly, the other wasn't as it was way too long. The other screw I found that waa probably from the flipper assembly was way too short (less than the 1/4"). The one that remained on the right assembly bracket had a lock washer (which is better than in the schematic).
Anyway, I can only assume that only a single screw was put on each bracket instead of two.
In any case, it was a less than 5 minutes fix to put new screws (with lock washers).
It now plays great!