Planetary Pinball Forum!

Medieval Madness Remake (MMR) => MMR Support [MMR Members Only] => Topic started by: PinDuo on July 16, 2016, 05:21:41 PM

Title: Coin acceptor for MMR
Post by: PinDuo on July 16, 2016, 05:21:41 PM

What type of coin acceptor can be put in the MMR?

Title: Re: Coin acceptor for MMR
Post by: schonb25 on July 16, 2016, 05:30:04 PM

http://www.planetarypinball.com/mm5/merchant.mvc?Store_Code=PP&Screen=PROD&Product_Code=PPS-09-8803

Title: Re: Coin acceptor for MMR
Post by: PinDuo on July 17, 2016, 10:28:18 AM

Thanks,
I use it as my bank for pinball repairs and parts.
Gotta pay to play

Title: Re: Coin acceptor for MMR
Post by: Rick7775 on July 25, 2016, 10:34:20 AM

OK... I'm a bit confused about this. I purchased two of these coin mechanisms for MMR (they're not too expensive so I thought it would be a good way to control how much the children play). When I went to install them, I discovered that the wiring harness for the game menu system runs right through the area where these should install. With the wiring there, there is no way to install the coin mechanism. I'm a bit concerned about cutting wiring mounts and trying to re-route all the wiring.

Has anyone done this? Is there any way to do it without simply leaving the wires hanging?

I need some help here.

Thanks

Title: Re: Coin acceptor for MMR
Post by: Lloyd Olson on July 25, 2016, 04:10:59 PM

I cut the cable ties holding my wiring to the door and was able to move/position the wires enough to get the mechs in.

LTG : )

Title: Re: Coin acceptor for MMR
Post by: Boxedbeef on July 26, 2016, 10:36:17 PM

I did same thing , Loyd had advised me previously and both mechs fit fine without cutting anything !