• July 25, 2024, 11:46:02 AM

Login with username, password and session length

NOTE: This forum is for respectful dialog and it's content is meant to be kept on this site - so please be respectful and please do not copy content to other sites.

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Lloyd Olson

Pages: 1 ... 15 16 [17]
241
MMR Support [MMR Members Only] / Re: Ball gets Stuck in Damsel Tower
« on: April 02, 2015, 05:36:02 PM »
Please turn the game off. Lift playfield and rest on the front of cabinet. Remove the right wireform to the right ramp. Remove the right ramp. No need to unplug them, you can position them out of the way so you can remove the damsel tower.

Then check it over. Something fall in there ? Switch stiff and catching ball ? Tower not positioned properly ?

Thank you,
LTG : )

242
MMR Support [MMR Members Only] / Re: MMR Shaker not working
« on: April 02, 2015, 01:29:11 PM »
Chicago Gaming has your information, and Doug inquired about your address to me, which I pointed out is on the ticket.

So right now I believe Doug is taking care of it.

Thank you,
LTG : )

243
MMR Support [MMR Members Only] / Re: MMR Shaker not working
« on: March 31, 2015, 12:41:55 AM »
Please disconnect the shaker motor for now.

Email me You are not allowed to view links. Register or Login and see what to do to get you a new motor. Yours has a dead winding.

You likely have to register on the help desk and open a ticket.

Thank you,
Lloyd

244
MMR Support [MMR Members Only] / Re: MMR Shaker not working
« on: March 30, 2015, 06:38:38 PM »
On the shaker motor.

Please look into the power supply on the right side of the cabinet, right inside the coin door. CR2 fuse/LED should be on ( green ) when the shaker motor is running.

From the power supply J6 goes to J4 on the controller board. Those would be the spots to check for loose connector/wire.

LTG : )

245
MMR Support [MMR Members Only] / Re: MMR Shaker not working
« on: March 30, 2015, 01:58:01 PM »
If you have a meter, please take the cover off and see if you have power to the motor when it should be turning.

Then we know where next, motor issue or not getting power.

Thank you,
LTG : )

246
All Things Pinball / Re: RECENT FINDS!
« on: January 08, 2015, 04:17:59 PM »
1986 Black Belt.

LTG : )

247
FAST Pinball / Re: FAST WPC 2.0
« on: December 09, 2014, 10:03:33 PM »
Contact Rick at PPS.

LTG : )

Pages: 1 ... 15 16 [17]