• June 12, 2024, 02:26:39 PM

Login with username, password and session length

NOTE: This forum is for respectful dialog and it's content is meant to be kept on this site - so please be respectful and please do not copy content to other sites.

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - schonb25

Pages: [1] 2 3
1
Attack From Mars Remake (AFMR) / Re: How to update your AFMr code
« on: July 29, 2017, 02:51:11 PM »
You are not allowed to view links. Register or Login
Has a code update been released?

Yes. The update includes new strobe brightness options (four levels of brightness from blinding to ridiculous) and ramp diverter coil strength.

2
Attack From Mars Remake (AFMR) / How to update your AFMr code
« on: July 27, 2017, 11:16:00 PM »
Hey all,


I created a how-to-guide for updating your AFMr code on Mac:


You are not allowed to view links. Register or Login


Enjoy!
Marc

3
MMR Support [MMR Members Only] / Re: Rubber ring map
« on: May 28, 2017, 11:37:06 AM »
I put the Titan silicon rings on all my games. They clean easy and last a long time, I like them. It's totally YMMV.


Marc

4
MMR Support [MMR Members Only] / Re: MMr left out lane lights
« on: April 26, 2017, 12:01:21 AM »
Did a new board fix your issue?

5
MMR Support [MMR Members Only] / Re: MMr left out lane lights
« on: April 19, 2017, 10:20:41 AM »
I would see if you can get your original board repaired. Looking at the schematic, it's not a complicated circuit to that board, so you just need to send the schematic to a qualified board tech who does SMD. Ping Clive at Coin Op Cauldron and see if he's willing to give it a shot.

Marc

6
MMR Support [MMR Members Only] / Re: MMr left out lane lights
« on: April 17, 2017, 05:07:12 PM »
I can do that when I'm home. But I can look at the schematic now.

7
MMR Support [MMR Members Only] / Re: MMr left out lane lights
« on: April 17, 2017, 11:42:55 AM »
Which connector is that light board on? I'll look at the schematic and try to figure it out.




8
MMR Support [MMR Members Only] / Re: MMr left out lane lights
« on: April 16, 2017, 03:54:42 PM »
If you take the left land board and plug it into the right, does it work? The schematic is daily simple for the lights, so, there's not that much that could go wrong. Have you asked CGC about ho to get it repaired and who is authorized to do so?

9
MMR Support [MMR Members Only] / Re: Difficulty shooting Merlin Magic
« on: January 29, 2017, 10:08:30 PM »
Same on the original. Some drop dead foam on the back of the metal will help a lot.

10
MMR Support [MMR Members Only] / Re: Drawbridge and some other Problems
« on: October 07, 2016, 05:56:49 PM »
.

11
MMR Support [MMR Members Only] / Re: Time and date resetting- new code
« on: September 13, 2016, 12:40:36 PM »
Hi folks,

Please file support tickets with CGC on their website for help. If replacing the battery did not fix the issue, there is likely something else going on with the board an CGC will help if you contact them and file a ticket.

Marc

12
MMR Support [MMR Members Only] / Re: 2.01
« on: August 27, 2016, 06:10:00 PM »
You hve it right. 1.0 is the Williams version. 2.0.1 is the CGC software. You'll always see 1.0 on the DMD when you boot. The CGC service menu will show you the MMR version of 2.0.1.

Marc

13
MMR Support [MMR Members Only] / Re: No display on start up.
« on: August 25, 2016, 11:14:59 PM »
Yes you do. A quick no signal is normal, but everything else you describe is not.

Marc

14
I changed my battery and did not lose game settings.

15
My advice is to have the machine powered off. If you drop the battery or anything else while the machine is on, you could be a lot more unhappy with shorting a board out, than if scores were reset. I do not expect it to reset your scores, but I have not done the battery swap yet.


Marc

Pages: [1] 2 3