Messages

1

MMR Support [MMR Members Only] / Re: Left kickup from the moat

« on: June 02, 2015, 06:53:42 PM »

I didnt see any way to rotate it one bit, screws holding it to the PF are holes not slots.


I did take and bend the bottom of the coil asy toward the bottom of the game as the whole thing looked like it was bent slightly outward(toward the cabinet side).  I think this was causing the ball to fire toward the back of the shoot and possibly even catching the edge. Once I bent it slightly(1/16"-3/32" maybe) inward so that it would shoot more toward the outlet of the shoot I ran about 30 balls at the lowest coil setting and then 30 more at max and no problems.


It is fixed

2

MMR Support [MMR Members Only] / Re: Left kickup from the moat

« on: May 31, 2015, 08:05:42 PM »

I will have to double check that it had a sleeve but when I was inspecting/ trying to figure out what to adjust I know the plunger was not sloppy or tight.  coils was tight, rubber grommet was there.


seems to get a good kick, its like its getting hit at an angle.   
I tried all the power settings and nothing seemed to make it better or worse


no easy way to watch it but seems to bounce around in there and not shoot straight up?

3

MMR Support [MMR Members Only] / Left kickup from the moat

« on: May 31, 2015, 05:25:18 PM »

having a problem with the popper that kicks the ball back up from the moat.
Some times it takes 2,3,4,5.... times for it to make it onto the playfield.
I tried all the settings for the coil and nothing fixed it, although it might have been 5% better when set to min.


I do not see any physical way to adjust anything?
is there something I am missing?


I had to fix the shooter lane kickout, that was no problem.
other than that #192 has been flawless since being picked up in Chicago in person.