Medieval Madness Remake (MMR) > MMR Support [MMR Members Only]

Ball will not load into plunger and plunger does not initiate

(1/1)

tomemerson7:
This weekend I got an error message when I powered up my game that the time and date needed to be set. I set the time and date and then went to play a game. After initiating a game, everything seemed fine except a ball did not load for the plunger.  The plunger light was on and hit the plunger anyway and nothing happened except the plunger light went out.


I powered down and powered back up and did not receive any error messages. The game reset but would not load a ball. Any suggestions as to what I should do or check?

Lloyd Olson:
Please check wiring at ball trough coil, and follow the wires to where it connects to, and it's fuse.

LTG : )

tomemerson7:
Checked the wires and reseated the associated connector on the associated solenoid driver board. The connector must have been the issue as it is working now.  Thanks for help.


One more question there are 3 fuses and 8 solenoid drivers/connectors on the solenoid driver board, how are the fuses mapped to the drivers/connectors or which fuse support which drivers?

Lloyd Olson:
Page 2 of the manual lists coils and flashers - which connector and fuse.

LTG : )

Navigation

[0] Message Index