Medieval Madness Remake (MMR) > MMR Support [MMR Members Only]

Ball consistently down middle from the Right upper chute

(1/3) > >>

BB13:
Looking for help for a likely small adjustment which will greatly improve the play of the game.  About 90% of the time, when a ball comes down from the right, either after the initial shot or when the ball goes into the Merlin's Magic "hole" and gets kicked out to the right... the ball comes down the chute, grazes a little black piece... and then perfectly goes down the middle and ends the turn.  On the first shots, it gives a Magic Shield and reshoots but its very challenging / frustrating to get any momentum / game play.


Does anyone have any advice as to how to adjust the small black bumper, or the metal strip (forming the chute) or the gate in order to change the trajectory so that it goes towards one of the flippers rather than dead center?


Appreciate,


Brad

Bmore:
I'm experiencing the same, did you get this resolved?

hocuslocus:
I was under the impression that after the ball goes down the right side it is supposed to hit the right flipper. (at least that's what someone told me). I honestly don't remember exactly how the game originally played. so I bent the piece of wire trying to guide the ball, but no matter how I bend it, it either went down the middle or hits the top of the right sling and bounces on the left flipper. I was contemplating buying another right ball gate assy just to seem how they are supposed to be bent, and since they are only $12. If the ball is going down with enough momentum it will hit the right flipper. I'm assuming this is the way it's supposed to play and my friend didn't know what he was talking of.

right gate assy link -
You are not allowed to view links. Register or Login

Lloyd Olson:
It should divert the ball to the right and not down the middle.

Yours may have gotten bent. May need adjusting. Or remove one screw and turn it a little.

LTG : )

Bmore:
I can't figure out what to adjust. If the ball comes down from the top it lands nicely on the flipper, if it stops at the guide/gate it hits the top of the slingshot and bounces to the middle. Should it be at an angle?

Navigation

[0] Message Index

[#] Next page