• October 05, 2024, 08:44:26 PM

Login with username, password and session length

NOTE: This forum is for respectful dialog and it's content is meant to be kept on this site - so please be respectful and please do not copy content to other sites.

Author Topic: Solenoid Driver Board  (Read 19873 times)

Offline Turbo27

  • PPS Forum Member
  • One Star Member
  • *
  • Posts: 15
  • Karma: +0/-0
    • View Profile
Solenoid Driver Board
« on: May 07, 2018, 12:01:36 AM »
During game play, LH troll remained up, even in test mode could hear coil powered.

Inspected Solenoid driver board, and mosfet Q7, troll power, with multi meter in diode test, gave open circuit reading - also compared to all other mosfet on board plus the other 2 solenoid driver boards.

Manual suggests part number NTP6412A, however part de-soldered is F3710Z. This part is also shown on  the PPS parts page as a replacement.

You are not allowed to view links. Register or Login

I'm in Australia and to buy a $2USD part plus $56USD is crazy!

Part listed in manual purchased locally

You are not allowed to view links. Register or Login

Tested with multi meter prior to fitting - reading are completely different. I'm not going to install without confirmation.

Any suggestions Lloyd  - Thanks in advance

Trent




Offline Turbo27

  • PPS Forum Member
  • One Star Member
  • *
  • Posts: 15
  • Karma: +0/-0
    • View Profile
Re: Solenoid Driver Board
« Reply #1 on: May 07, 2018, 12:41:05 AM »
I'll answer my own post.

Mosfet test with multi meter when NOT installed on board gives completely different readings.

Inserted mosfet onto board and retested, BINGO same readings. Now re-soldered back onto solenoid board and tested working.

Can you tell I hate repairing electronics !!!

Cheers

Offline Lloyd Olson

  • LTG : )
  • Global Moderator
  • Three Star Member
  • *****
  • Posts: 385
  • Karma: +18/-7
    • View Profile
Re: Solenoid Driver Board
« Reply #2 on: May 07, 2018, 01:28:40 PM »
Thank you for the update Trent !
Lloyd