• September 20, 2021, 03:58:15 AM

Login with username, password and session length

NOTE: This forum is for respectful dialog and it's content is meant to be kept on this site - so please be respectful and please do not copy content to other sites.

Author Topic: Right eject stopped working  (Read 5280 times)

Offline Goldfinger88

  • PPS Forum Member
  • One Star Member
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Right eject stopped working
« on: December 01, 2017, 07:29:57 PM »
My right eject stopped working.  It gives me the merlins award and makes the sound to eject but nothing happens.  I reset the connector but it did not work.  Any thoughts?

Offline Lloyd Olson

  • LTG : )
  • Global Moderator
  • Three Star Member
  • *****
  • Posts: 377
  • Karma: +17/-7
    • View Profile
Re: Right eject stopped working
« Reply #1 on: December 01, 2017, 07:52:11 PM »
Please enable the high power interlock switch on the coin door frame, and go to Tests - Solenoids - and see if it fires. If not, check for broken wire at the coil lugs, especially the thin ones coming from the coil to the lug.

If a lot of coils do't work, but some do. You may have blown a fuse.

You can open a ticket on the Support desk at chicago-gaming.com website, if the above doesn't get you going.

LTG : )

Offline Goldfinger88

  • PPS Forum Member
  • One Star Member
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Re: Right eject stopped working
« Reply #2 on: December 01, 2017, 08:02:02 PM »
In test it popped soft then at normal power.  It is working fine now, any ideas why it would have stopped and now works again?


Thanks Lloyd,


Jon

Offline Lloyd Olson

  • LTG : )
  • Global Moderator
  • Three Star Member
  • *****
  • Posts: 377
  • Karma: +17/-7
    • View Profile
Re: Right eject stopped working
« Reply #3 on: December 01, 2017, 11:03:12 PM »
If it happens again. I would reseat the connector from that coil to the driver board under the playfield a couple times. And that driver board is screwed and has ten pins that plug into the huge board under the playfield. Push that area in a little so it's seated tight.

Thank you,
LTG : )