Basic HTML Version
4. Raise the hinged backbox upright and stabilize it into position. Unlock the
backbox, and remove the backbox glass. storing it carefully to avoid scratches.
Remove the shipping block holding the Insert Board. This allows access to the
bolt holes used for securing the backbox upright. Install the mounting bolts,
split lockwashers, and flat washers through the bottom holes of the backbox
into the threaded fasteners in the cabinet to secure the backbox. Close and
latch the Insert Board, and install the backbox glass, and lock the backbox.
II
WARNING
II
NEVER
transport a pinball game with hinged backbox erect. Always lower the
backbox forward onto the playfield cabinet on a layer of protective material to
prevent marring or damage and possible personal injury.
5. Extend each leg leveller slightly below the leg bottom, so that all four foot pads
are extended about the same distance.
Remove the cabinet from its support
and place it on the floor.
6. Adjust the leg levellers for proper playfield level (side-to-side) and playfield pitch
angle (incline) of approximately 7 degrees. (Again, it is recommended that these
measurements be made ON the playfield, not the cabinet nor the playfield cover
glass.) Tighten the nut on each leg leveller shaft to maintain this setting, as
shown in Figure 3.
CAUTION
Playing pitch angle adjustments can affect the operation of the plumb bob
tilt. inside the cabinet. The plumb bob weight is among the parts in the cash
box; the operator should install the weight and adjust the tilt mechanism
for proper operation, after completion of the desired playfield pitch angle
setting.
7. Move the game into the desired location: recheck the level and pitch angle of the
playfield.
8, Verify that the required number of balls are inside the game.
GAME
SHOW
uses two (2) balls.
9. Clean and re-install the playfield cover glass. Prepare the game for player
operation.
1-6 Pinball Assembly Instructions