Basic HTML Version
PINBALL GAME ASSEMBLY INSTRUCTIONS
(Continued)
7. Unlock and open the coin door. locate the Molding latch lever (shown in Figure 2), and move the lever toward
the left side of the game, to release the Front Molding. lift the Front Molding off the pJayfield cover glass; return
the latch lever toward the right, and close the coin door. Carefully slide the glass downward, until it clears the
grooves of the left and Right Side Moldings. lift the glass up and away from the game, storing it carefully to avoid
breakage.
8. Place a level or an inclinometeron the playfield surface. Adjust the leg levellers for proper pJayfield level (side-
to-side) and playfield pitch angle (incline) of approximately 6-7 degrees. NOTE: It is recommended that these
measurements be made ON the playfield, not the cabinet nor the playfield cover glass. Tighten the nut on each
leg leveller shaft to maintain this setting, as shown in Figure 3.
POWERING UP. Perform the following 'power up' routine upon completion of the assembly and installation
procedure, as well as at the beginning of each period of game operation. Initially, it will confirm that the game is
in proper operating condition; later, it will aid the operator via its messages (refer to later text entitled "Problem
Analysis Messagesj.
<-
c ~ (J)){f'O@[jfj
Playfield pitch angle adjustments can affect the operation of the plumb bob tilt, inside the
cabinet. The plumb bob weight is among the parts in the cash box; the operator should
install the weight and adjust this tilt mechanism for proper operation, after completion of
the desired playfield pitch angle setting.
9. Move the game into the desired location; recheck the level and pitch angle of the playfield.
10. Verify that the
required number
of balls are installed in the game.
(ROLLERGAMES:
3 balls.)
11. Clean and reinstall the pJayfield cover glass, reversing the procedure of step 7. Prepare the game for
player operation.
GAME OPERATION
(
W~ml[jfjU[jfj@ )
After assembly and installation at its site location, this game must be plugged into a prop-
erly grounded outlet to prevent shock hazard, and to assure proper game operation. DO
NOT use a 'cheater' plug to defeat the ground pin on the line cord. DO NOT cut off the
ground pin.
Procedure.
With the coin door closed, plug the game in, and switch it ON, using the On-Off switch. In normal
operation, the player 1 score display initially shows 00. Then, the game goes into the Attract Mode (playfield and
backbox lamps flashing, sounds being heard, etc., if the operator does not change the Factory Setting).
Open the coin door and press the AUTO-UP/MANUAl-DOWN switch to MANUAL-DOWN.
Press the ADVANCE
button to begin the game test routine. Return to AUTO-UP and perform the entire test routine to verify that the
game is operating satisfactorily. Successful completion of the tests shows that the game is.ready to begin earning
your investment retum.
.
.
ROLLERGAMES 6