Rapid TAC Cleaner & Decal (Cabinet) Application Fluid - 4oz Spray Bottle
The Original Rapid Tac
Application Fluid
For fast, easy, quality installation of graphics with no bubbles, even in cold
weather.
Rapid Tac Application Fluid shocked installers by allowing them more control
over their applications than ever before. Now what took hours could be
accomplished in minutes. Using Rapid Tac Application fluid can often allow a
large graphic to be installed with one person where two people were required
to perform the same installation dry. Rapid Tac Application Fluid also cleans
the substrate without leaving residues ensuring a contaminant free
installation. It then helps to “float” the vinyl film until it is properly
positioned. Rapid Tac Application Fluid’s best feature is that it effectively
breaks the surface tension of the adhesive on the film allowing it to flow and
bond to the substrate more effectively than even a dry application. It is now
possible to achieve a full bond in as little as ninety seconds. Your customers
and your reputation will benefit from higher-quality applications. Your bottom
line will benefit from faster applications and less failures as well.
STEP 1. Clean
surface thoroughly with Rapid Tac and a kitchen paper towel. DO NOT USE OTHER
CLEANERS OR SOLVENTS.
(We do recommend Rapid Prep as a pre-cleaner for surfaces that may have been
exposed to wax, silicone, or other suspected contaminants)
STEP 2. Spray surface again with Rapid Tac, peel backing off decal and place on wet surface.
STEP 3. Position decal. Use squeegee to remove fluid, using a good deal of pressure and working from the center out to the edges in all directions.
STEP 4. Wait 2-3 minutes. Saturate paper cover tape, if any, with Rapid Tac, then remove paper tape. Wipe surface with paper towel.
Click here to learn more
about Rapid Tac II
Detailed Use Instructions