Planetary Pinball Forum!

Medieval Madness Remake (MMR) => MMR Support [MMR Members Only] => Topic started by: Cam on November 20, 2015, 01:37:13 PM

Title: Drawbridge not fully closing
Post by: Cam on November 20, 2015, 01:37:13 PM

Hi Lloyd
The drawbridge opens fine but does not fully close.  There is a gap of about one inch... The playfield is level.  If you elevate the playfield then it closes in test mode.  Tried adjusting the switch to no avail.
Thx

Title: Re: Drawbridge not fully closing
Post by: Lloyd Olson on November 20, 2015, 02:45:42 PM

You can loosen the allen head set screw on the link that hooks to the draw bridge axle, and try and adjust it a little.

It does hang open a bit.

Thank you,
Lloyd

Title: Re: Drawbridge not fully closing
Post by: calvin12 on November 26, 2015, 09:51:45 AM

the bridge never closes fully on its own. it should be open. It can get pushed back to fully closed by a ball smacking it. being left partly open directs balls down into the moat. When it does get bashed hard enough to close fully you can get airballs back over the moat

Title: Re: Drawbridge not fully closing
Post by: stangbat on November 26, 2015, 09:29:41 PM

The drawbridge does not fully close.  Drawbridges do not fully close.   Google them, you'll see they stay open a little bit due to the inherent design of the system.  Let it hang open, that's how it is supposed to look.