• April 24, 2024, 02:17:19 PM

Login with username, password and session length

NOTE: This forum is for respectful dialog and it's content is meant to be kept on this site - so please be respectful and please do not copy content to other sites.
« previous next »
Pages: [1]   Go Down

Author Topic: Drawbridge not fully closing  (Read 9027 times)

Offline Cam

  • PPS Forum Member
  • Two Star Member
  • *
  • Posts: 90
  • Karma: +0/-0
    • View Profile
Drawbridge not fully closing
« on: November 20, 2015, 01:37:13 PM »
Hi Lloyd
The drawbridge opens fine but does not fully close.  There is a gap of about one inch... The playfield is level.  If you elevate the playfield then it closes in test mode.  Tried adjusting the switch to no avail.
Thx
Logged

Offline Lloyd Olson

  • LTG : )
  • Global Moderator
  • Three Star Member
  • *****
  • Posts: 385
  • Karma: +18/-7
    • View Profile
Re: Drawbridge not fully closing
« Reply #1 on: November 20, 2015, 02:45:42 PM »
You can loosen the allen head set screw on the link that hooks to the draw bridge axle, and try and adjust it a little.

It does hang open a bit.

Thank you,
Lloyd
Logged

Offline calvin12

  • PPS Forum Member
  • One Star Member
  • *
  • Posts: 24
  • Karma: +0/-1
    • View Profile
Re: Drawbridge not fully closing
« Reply #2 on: November 26, 2015, 09:51:45 AM »
the bridge never closes fully on its own. it should be open. It can get pushed back to fully closed by a ball smacking it. being left partly open directs balls down into the moat. When it does get bashed hard enough to close fully you can get airballs back over the moat
Logged

Offline stangbat

  • PPS Forum Member
  • One Star Member
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Re: Drawbridge not fully closing
« Reply #3 on: November 26, 2015, 09:29:41 PM »
The drawbridge does not fully close.  Drawbridges do not fully close.   Google them, you'll see they stay open a little bit due to the inherent design of the system.  Let it hang open, that's how it is supposed to look.
Logged
Pages: [1]   Go Up
« previous next »