• August 21, 2018, 08:29:52 PM

Login with username, password and session length

NOTE: This forum is for respectful dialog and it's content is meant to be kept on this site - so please be respectful and please do not copy content to other sites.

Author Topic: Problem With Ball Trough  (Read 93 times)

Offline Ding

  • PPS Forum Member
  • One Star Member
  • *
  • Posts: 4
  • Karma: +0/-0
    • View Profile
Problem With Ball Trough
« on: August 09, 2018, 08:21:41 PM »
I'm having an issue with balls getting stuck in the Ball Trough. The coil ejector device that ejects the ball out of the Ball Trough has a black plastic ring around it (Coil Tubing?). It appears that this black plastic tube is extending a little too far up into the ball trough obstructing the balls from being right over the plunger so that they can be ejected from the Trough. I can push the black plastic tube down a little to relieve the obstruction, but it keeps recurring. Any ideas how to fix this?

Offline Lloyd Olson

  • LTG : )
  • Global Moderator
  • Three Star Member
  • *****
  • Posts: 360
  • Karma: +16/-7
    • View Profile
Re: Problem With Ball Trough
« Reply #1 on: August 10, 2018, 12:07:42 AM »
Hello 

The coil and plunger is fastened to a bracket. This bracket is fastened to the end of the ball trough by four screws on the opposite side of the coil. Loosen them and move the whole bracket down a tiny bit. Not too much.
Do that and you should be good to go.
Thank you,LTG : )

Offline Ding

  • PPS Forum Member
  • One Star Member
  • *
  • Posts: 4
  • Karma: +0/-0
    • View Profile
Re: Problem With Ball Trough
« Reply #2 on: August 13, 2018, 08:57:52 AM »
Thanks Lloyd. That worked perfectly!